This is an example of output from the show ethernet service instance detail command:
Router# show ethernet service instance id 1 interface gigabitEthernet 0/1 detail
Service Instance ID: 1
Associated Interface: GigabitEthernet0/0/13
Associated EVC: EVC_P2P_10
L2protocol drop
CE-Vlans:
Encapsulation: dot1q 10 vlan protocol type 0x8100
Interface Dot1q Tunnel Ethertype: 0x8100
State: Up
EFP Statistics:
Pkts In Bytes In Pkts Out Bytes Out
214 15408 97150 6994800
EFP Microblocks:
****************
Microblock type: Bridge-domain
Bridge-domain: 10
This is an example of output from the show bridge-domain command:
Router# show bridge-domain 100
Bridge-domain 100 (1 ports in all)
State: UP Mac learning: Enabled
Aging-Timer: 300 second(s)
Maximum address limit: 256000
GigabitEthernet0/0/0 service instance 1
Nile Mac Address Entries
BD mac addr type ports
----------------------------------------------------------------------------------------------
100 0000.bbbb.cccc STATIC Gi0/0/0.Efp1
sh mac-address-table bdomain 100
Nile Mac Address Entries
BD mac addr type ports
----------------------------------------------------------------------------------------------
100 0000.bbbb.cccc STATIC Gi0/0/0.Efp1
This is an example of output from the show ethernet service instance statistics command:
Router# show ethernet service instance id 1 interface gigabitEthernet 0/0/13 stats
Service Instance 1, Interface GigabitEthernet0/0/13
Pkts In Bytes In Pkts Out Bytes Out
214 15408 97150 6994800
This is an example of output from the show mac-address table count command:
Router# show mac address-table count bridge-domain 10
Mac Entries for BD 10:
---------------------------
Dynamic Address Count : 20
Static Address Count : 0
Total Mac Addresses : 20
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
48
Ethernet Virtual Connections Configuration
Monitoring EVC