Cisco ASR 920 series Configuration Guide Ethernet Router

Example
The following example configures cross-checking on an inward facing MEP (U-PE B)
U-PE B
ethernet cfm domain ServiceProvider level 4
mep crosscheck mpid 401 vlan 100
!
ethernet cfm mep crosscheck start-delay 60
The following example enables cross-checking on an inward facing MEP (U-PE B)
U-PE B
U-PEB# ethernet cfm mep crosscheck enable level 4 vlan 100
Configuring and Enabling Cross-Checking for an Outward Facing MEP on the CE-A
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ethernet cfm domain domain-name level level-id [direction outward]
4.
mep crosscheck mpid id vlan vlan-id [mac mac-address]
5.
exit
6.
ethernet cfm mep crosscheck start-delay delay
7.
exit
8.
ethernet cfm mep crosscheck {enable | disable} level {level-id | level-id-level-id [,level-id-level-id]}
vlan {vlan-id | any | vlan-id-vlan-id [,vlan-id-vlan-id]}
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Defines a CFM domain at a specified level and enters
Ethernet CFM configuration mode.
ethernet cfm domain domain-name level level-id
[direction outward]
Example:
Device(config)# ethernet cfm domain Customer level
7 direction outward
Step 3
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
194
Configuring Ethernet Connectivity Fault Management in a Service Provider Network
Configuring Ethernet CFM

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English