Cisco ASR 920 series Configuration Guide Ethernet Router

PurposeCommand or Action
Statically defines a remote MEP with a specified ID,
VLAN, and domain.
mep crosscheck mpid id vlan vlan-id [mac mac-address]
Example:
Device(config-ether-cfm)# mep crosscheck mpid 702
vlan 100
Step 4
Returns to global configuration mode.exit
Example:
Device(config-ether-cfm)# exit
Step 5
Configures the maximum amount of time that the
device waits for remote MEPs to come up before the
cross-check operation is started.
ethernet cfm mep crosscheck start-delay delay
Example:
Device(config)# ethernet cfm mep crosscheck
start-delay 60
Step 6
Returns to privileged EXEC mode.exit
Example:
Device(config)# exit
Step 7
Enables cross-checking between MEPs.ethernet cfm mep crosscheck {enable | disable} level
{level-id | level-id-level-id [,level-id-level-id]} vlan {vlan-id
| any | vlan-id-vlan-id [,vlan-id-vlan-id]}
Step 8
Example:
Device# ethernet cfm mep crosscheck enable level 7
vlan 100
Configuring and Enabling Cross-Checking for an Outward Facing MEP on the CE-B
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ethernet cfm domain domain-name level level-id [direction outward]
4.
mep crosscheck mpid id vlan vlan-id [mac mac-address]
5.
exit
6.
ethernet cfm mep crosscheck start-delay delay
7.
exit
8.
ethernet cfm mep crosscheck {enable | disable} level {level-id | level-id-level-id [,level-id-level-id]}
vlan {vlan-id | any | vlan-id-vlan-id [,vlan-id-vlan-id]}
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
195
Configuring Ethernet Connectivity Fault Management in a Service Provider Network
Configuring Ethernet CFM

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English