Cisco ASR 920 series Configuration Guide Ethernet Router

DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Specifies the interface type and number and enters interface
configuration mode.
interface type number
Example:
Device(config)# interface ethernet 0/1
Step 3
Enables an LLDP-MED TLV or LLDP packet transmission
on a supported interface.
lldp {med-tlv-select tlv | receive | transmit}
Example:
Device(config-if)# lldp transmit
Step 4
Returns to privileged EXEC mode.end
Example:
Device(config-if)# end
Step 5
Setting LLDP Packet Hold Time
Hold time is the duration that a receiving device should maintain LLDP neighbor information before aging
it. Perform this task to define a hold time for an LLDP-enabled device.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
lldp holdtime seconds
4.
end
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
336
Using Link Layer Discovery Protocol in Multivendor Networks
Setting LLDP Packet Hold Time

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English