Cisco ASR 920 series Configuration Guide Ethernet Router

DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Defines an outward CFM domain at a specified level and
enters Ethernet CFM configuration mode.
ethernet cfm domain domain-name level level-id
Example:
Device(config)# ethernet cfm domain Customer
level 7
Step 3
Configures a maintenance association within a maintenance
domain and enters Ethernet connectivity fault management
(CFM) service configuration mode.
service short-ma-name evc evc-name vlan vlanid
direction down
Example:
Device(config-ecfm)# service s41 evc 41 vlan 41
direction down
Step 4
Statically defines the MEPs within a maintenance
association.
mep mpid mpid
Example:
Device(config-ecfm)# mep mpid 702
Step 5
Returns the device to global configuration mode.exit
Example:
Device(config-ecfm)# exit
Step 6
Configures the maximum amount of time that the device
waits for remote MEPs to come up before the cross-check
operation is started.
ethernet cfm mep crosscheck start-delay delay
Example:
Device(config)# ethernet cfm mep crosscheck
start-delay 60
Step 7
Returns the device to privileged EXEC mode.exit
Example:
Device(config)# exit
Step 8
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
270
Configuring Ethernet CFM
Configuring Ethernet CFM

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English