Cisco ASR 920 series Configuration Guide Ethernet Router

Configuring CFM over Bridge Domains
Perform this task to configure Ethernet CFM over bridge domains. This task is optional.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ethernet cfm domain domain-name level level-id direction outward
4.
service csi-id evc evc-name
5.
exit
6.
ethernet cfm domain domain-name level level-id
7.
exit
8.
ethernet cfm domain domain-name level level-id
9.
service csi-id evc evc-name
10.
mep crosscheck mpid id evc evc-name mac mac-address
11.
exit
12.
ethernet evc evc-name
13.
exit
14.
interface type number
15.
no ip address
16.
service instance id ethernet evc-id
17.
encapsulation dot1q vlan-id
18.
bridge-domain bridge-id
19.
cfm mep domain domain-name mpid mpid-value
20.
end
21.
configure terminal
22.
interface type name
23.
no ip address
24.
ethernet cfm mip level level-id
25.
service instance id ethernet evc-id
26.
encapsulation dot1q vlan-id
27.
bridge-domain bridge-id
28.
cfm mep domain domain-name mpid mpid-value
29.
end
30.
configure terminal
31.
ethernet cfm cc enable level level-id evc evc-name
32.
ethernet cfm cc level any evc evc-name interval seconds loss-threshold num-msgs
33.
end
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
197
Configuring Ethernet Connectivity Fault Management in a Service Provider Network
Configuring Ethernet CFM

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English