Cisco ASR 920 series Configuration Guide Ethernet Router

PurposeCommand or Action
• interface_type—Specifies the Gigabit Ethernet or Ten Gigabit
Ethernet interface.
Example:
Router(config-mon-local)# source interface
gigabitethernet 0/2/1 rx
◦ slot/subslot/port—The location of the interface.
• “,”—List of interfaces
• “–”—Range of interfaces
• rx—Ingress local SPAN
• tx—Egress local SPAN
•
both
Specifies the destination interface that sends both ingress and egress
local spanned traffic from source port to the prober or sniffer.
destination interface interface_type
slot/subslot/port [, | -]
Step 4
Example:
Router(config-mon-local)# destination
interface gigabitethernet 0/2/4
• interface_type—Specifies the Gigabit Ethernet or Ten Gigabit
Ethernet interface.
◦ slot/subslot/port—The location of the interface.
• “,”—List of interfaces
• “–”—Range of interfaces
Enables the local SPAN session.no shutdown
Example:
Router(config-mon-local)# no shutdown
Step 5
Removing Sources or Destinations from a Local SPAN Session
To remove sources or destinations from a local SPAN session, use the following commands beginning in
EXEC mode:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
no monitor session session-number
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
390
Configuring Switched Port Analyzer
Removing Sources or Destinations from a Local SPAN Session

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English