Cisco ASR 920 series Configuration Guide Ethernet Router

How to Configure G.8032 and CFM Support for Microwave
Adaptive Bandwidth
Creating the Ethernet Microwave Event and Using G.8032 to Specify Appropriate
Actions
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
event manager applet applet-name
4.
event ethernet microwave sd {interface type number [mac-address mac_address | link-id link-id
]threshold threshold-bandwidth}
5.
action action-id switch ring g8032 ring-name instance instance-id
6.
event ethernet microwave clear-sd {interface type number}
7.
action action-id switch ring g8032 clear ring-name instance {instance-id | all}
8.
Repeat steps 4 through 7 for each Ethernet microwave event you want to create. Then proceed to step 9.
9.
exit
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Registers an applet with the Embedded Event Manager
(EEM) and enters applet configuration mode.
event manager applet applet-name
Example:
Device(config)# event manager applet mw_ring_sd1
Step 3
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
237
G.8032 and CFM Support for Microwave Adaptive Bandwidth
How to Configure G.8032 and CFM Support for Microwave Adaptive Bandwidth

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English