Cisco ASR 920 series Configuration Guide Ethernet Router

SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ethernet cfm domain domain-name level level-id
4.
service short-ma-name evc evc-name vlan vlanid direction down
5.
continuity-check
6.
continuity-check [interval cc-interval]
7.
exit
8.
mep archive-hold-time minutes
9.
exit
10.
ethernet cfm global
11.
ethernet cfm traceroute cache
12.
ethernet cfm traceroute cache size entries
13.
ethernet cfm traceroute cache hold-time minutes
14.
interface type number
15.
service instance id ethernet [evc-name]
16.
encapsulation encapsulation-type
17.
bridge-domain bridge-id
18.
cfm mep domain domain-name mpid id
19.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Defines a CFM maintenance domain at a particular
maintenance level and enters Ethernet CFM configuration
mode.
ethernet cfm domain domain-name level level-id
Example:
Device(config)# ethernet cfm domain Customer
level 7
Step 3
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
163
Configuring Ethernet Connectivity Fault Management in a Service Provider Network
Configuring Ethernet CFM

Cisco ASR 920 series Specifications

General

Form Factor	1RU
Operating System	Cisco IOS XE
Model	ASR 920 series
Memory	4 GB DRAM
Power Supply	AC or DC
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Relative Humidity	5% to 95% non-condensing
MTBF	Varies by model
Management	CLI, SNMP