Dahua JRC-27F User Manual

User's Manual
245
Table 5-43 Alarm linkage parameters
Parameter Description
Anti-Dither
The system records only one motion detection event within the defined
period.
Alarm-out Port When an alarm occurs, the NVR links the alarm output device to generate
an alarm. The alarm lasts a period of time depending on the defined
value for
Post-Alarm
.
●
Make sure that the alarm devices are connected to the alarm output
port of NVR.
●
In
Main Menu
>
ALARM
>
Alarm-out Port
, set the mode to
Auto
so
that the system can link the alarm output device to generate an
alarm.
Post-Alarm
Show Message Enable on-screen prompt when an alarm occurs.
Report Alarm
Enable the system to report the alarm to the alarm center.
Make sure that alarm center has been configured in
Main Menu
>
NETWORK
>
Alarm Center
.
Send Email
Enable the system to send an email to notify you when an alarm occurs.
Make sure that the email settings have been configured in
Main Menu
>
NETWORK
>
Email
.
Record Channel When an alarm occurs, the system activates recording of the selected
channel. After the alarm ends, the recording continues for a period of
time depending on the defined value for
Post-Record
.
Make sure that intelligent recording schedule and auto recording have
been configured. For details, see "5.8.1 Recording Schedule".
Post-Record
PTZ Linkage
When an alarm occurs, the NVR associates the channel to perform the
corresponding PTZ action. For example, rotate the PTZ to the preset
point.
Make sure that PTZ actions have been configured. For details, see "5.6.7
PTZ".
Tour
When an alarm occurs, the local interface of the NVR displays the image
of the selected channels in turn.
Make sure that the time interval and mode for tour have been
configured in
Main Menu
>
DISPLAY
>
Tour Setting
.

Dahua JRC-27F Specifications

General

Brand	Dahua
Model	JRC-27F
Category	Network Hardware
Language	English