Dahua JRC-27F User Manual

User's Manual
292
5.11.17 Switch
After setting
Switch
, when an IPC is connected to the PoE port, the system automatically assigns the
IP address to the IPC according to the defined IP segment, and the NVR will automatically connect to
the IPC.
●
Only models with PoE ports support this function.
●
Do not connect the PoE port with a switch, otherwise it will cause connection failure.
●
This function is enabled by default, and the IP segment start from 10.1.1.1. We recommend you
use the default setting.
●
When connecting to a third-party IPC, make sure that the IPC supports ONVIF protocol and DHCP
is enabled.
Procedure
Step 1 Select
Main Menu
>
NETWORK
>
Switch
.
Figure 5-202 Switch
Step 2 Configure IP address, subnet mask, and default gateway..
Do not set the IP address to the same network segment with the NVR. We recommend you
use the default setting.
Step 3 Click
Apply
.
When connecting IP camera to PoE port, if all the channels are occupied, the system prompts you
whether to take place of one channel.

Dahua JRC-27F Specifications

General

Brand	Dahua
Model	JRC-27F
Category	Network Hardware
Language	English