Dahua JRC-27F User Manual

User's Manual
288
Figure 5-198 SNMP
Step 2 Click to enable the function.
Step 3 Configure the parameters.
Table 5-60 SNMP parameters
Parameter Description
Version
Select the checkbox of SNMP version that you are using.
The default version is
V3
. There is a risk if you use V1 or V2.
SNMP Port Enter the monitoring port on the agent program.
Read Community
Enter the read and write strings supported by the agent program.
Write Community
Trap Address
Enter the destination address for the agent program to send the Trap
information.
Trap Port
Enter the destination port for the agent program to send the Trap
information.
Read-Only
Username
Enter the username that is allowed to access the Device and has the
read-only permission.
Read/Write
Username
Enter the username that is allowed to access the Device and has the read
and write permission.
Authentication Type Select MD5 or SHA. The system recognizes the type automatically.
Authentication
Password
Enter the password for authentication. The password should be no less
than eight characters.

Dahua JRC-27F Specifications

General

Brand	Dahua
Model	JRC-27F
Category	Network Hardware
Language	English