3-8 Routine Maintenance
Laminator Routine Maintenance Procedures
The entire routine maintenance procedure should be completed each time the
laminator is serviced. This will help extend the life of the printer.
 Refer to chapter 6 of this manual for removal and replacement procedures.
CAUTION: Do not spray or pour cleaner directly on or into any electrical
device.
Clean the Interior of the Laminator
1. Unplug the printer.
2. Remove the printer enclosures.
3. Remove the printer from the laminator.
4. Using canned compressed air:
• Blow out any debris near the sensors.
• Blow out any dust from the control board and other surfaces of the base.
• Blow out any dust and debris from the underside of the chassis.
5. If the grease on the platen roller shafts has accumulated dirt and debris, wipe
off the grease with a dry cloth, and re-grease the surfaces with Molykote DX
grease.
6. Inspect the heated rollers for adhered debris. If necessary, remove the
assembly and clean with isopropanol.
To Next Page
Loading...
Need help?
General
