To Next Page

To Previous Page

Opening the console

The console is a protruding plastic banner on the front of the cabinet with a stripe of

blue or green light and the product badge.

If the console is covering the front of the shelf to which you need access, open the

console using the steps that follow.

Procedure

1. Grasp the right side of the console.

2. Pull the console to swing it open.

Figure 77 Opening the console

CL4699

Removing the front bezel

NOTICE

You must remove the front bezel to gain access to the internal components. The bezel

is required for EMI compliance when the shelf is powered up. Remove it only to

replace or add an internal component.

Procedure

1. If the bezel has a lock, insert the key that shipped with your shelf into the lock,

and turn the key to unlock the bezel.

2. Press the two latch buttons on the bezel surface to release the bezel from the

cabinet.

3. Pull the bezel off the cabinet and put it on a clean, static-free surface.

Removing and Replacing FRUs

104 EMC Data Domain DS60 Expansion Shelf Installation and FRU Replacement Hardware Guide

Questions and Answers:

Need help?

Do you have a question about the EMC Data Domain DS60 and is the answer not in the manual?

EMC Data Domain DS60 Specifications

General