Figure 40 Removing the straps
1U cable management tray installation (underneath)
This section describes how to install the 1U cable management tray.
Racks and rails
You can secure the 1U cable tray to EMC and non-EMC racks with a sliding rail
system.
The rail kits are included in the cable tray packaging and are compatible with racks
with the following types of holes:
l
3/8 inch square holes
l
9/32 inch round holes
l
10-32, 12-24, M5X.8, or M6X1 pre-threaded holes
The following table shows the hardware and the recommended rack types:
Hardware from kit
Part Number and
Description
Recommended Rack
Type
036-034-012
Custom Male-Female 8-32 x .
75 screw
Always used to secure rails,
regardless of Rack Type
036-034-003
Custom square hole pin
These replace the adaptors
that come pre-installed in the
rails. Used in racks that have .
375" square hole mounting
rails.
Shelf Installation and Removal
52 EMC Data Domain DS60 Expansion Shelf Installation and FRU Replacement Hardware Guide
To Next Page
Loading...
Need help?
General
