To Next Page

To Previous Page

Reconfiguring the lift with Voyager kit

If you are using the Alum-A-Lift for installations or removals above 49 inches (28U),

you must use the single (lower) mast configuration with the "Voyager" conversion kit

and support table.

NOTICE

The "Voyager conversion kit," is used with multiple systems.

Procedure

1. Unpack the Voyager kit.

2. Use the instructions to provided within the kit to reconfigure the lift.

Figure 119 Reconfiguring the portable lift with the Voyager conversion kit

CL5422

1 2

Adjusting the arms for a frontal lift

If you plan to use the mechanical lift directly in front of the cabinet, adjust the lift

arm/tray width to just under 17 inches apart to ensure that the arms will stay under

the chassis. Figure 120 on page 139 shows an example of adjusting the lift arm/tray

to just under 17 inches.

Procedure

1. Add the two arms with rollers 17 inches apart measured from the outside edge

of each arm.

2. Tighten the arms to secure them.

Removing and Replacing FRUs

138 EMC Data Domain DS60 Expansion Shelf Installation and FRU Replacement Hardware Guide

Questions and Answers:

Need help?

Do you have a question about the EMC Data Domain DS60 and is the answer not in the manual?

EMC Data Domain DS60 Specifications

General