To Next Page

To Previous Page

Removing the universal rails

This procedure describes how to remove the universal rails from an EMC or non-EMC

rack. This procedure assumes the shelf that was installed in the rails has been

removed.

Figure 67 Removing the universal rails

CL5555

3 4

Procedure

1. Remove the center long screw from the front of the rail (1).

2. At the front of the rail, pull the retaining clip free from the rack channel and pull

the rail from the front of the rack until the adaptors are free from the cabinet

mounting holes (2).

3. At the rear of the rack, remove the center long screw from the rear of the rail

(3).

4. Push in the rear rail retaining clip and pull the rail until the adaptors are free

from the cabinet mounting holes (4). Remove the rail.

5. Repeat for the other rail.

Shelf Installation and Removal

74 EMC Data Domain DS60 Expansion Shelf Installation and FRU Replacement Hardware Guide

Questions and Answers:

Need help?

Do you have a question about the EMC Data Domain DS60 and is the answer not in the manual?

EMC Data Domain DS60 Specifications

General