To Next Page

To Previous Page

Figure 26 Tightening the straps

1 2

CL5429

c. Make sure the shelf is securely strapped to the lift before moving. Once the

shelf is supported by the arm, lower the arm to the lowest point that still

permits travel.

This allows the shelf to be moved with minimal danger of tipping over.

10. Unlock the casters by lifting up on the locking tabs and move the shelf as

required.

Figure 27

Unlocking the casters

CL5424

Using the lift on a shelf more than 49" above the floor

If you are using an Alum-A-Lift to work on a shelf that is more than 49 inches above

the floor, you must use the "Voyager" conversion kit and a support table with the

lower mast configuration.

Procedure

1. If necessary, orient the arm to the high-lift position as follows:

Shelf Installation and Removal

44 EMC Data Domain DS60 Expansion Shelf Installation and FRU Replacement Hardware Guide

Questions and Answers:

Need help?

Do you have a question about the EMC Data Domain DS60 and is the answer not in the manual?

EMC Data Domain DS60 Specifications

General