EMC Data Domain DS60 User Manual

Verify system health
Verify the system is healthy before proceeding with the upgrade procedure.
Procedure
1. Log in as a sysadmin user.
2. Display the current alerts on the system.
Run the following command:
alerts show current
# alerts show current
No active alerts.
3. Resolve all displayed alerts.
Identify the first empty disk pack in the target enclosure
The DS60 contains four disk packs. Each disk pack is a 15 disk grouping, three disks
wide by five disks deep. Identify the disk pack where the new disks will be installed.
Procedure
1. Display the enclosures and disks installed on the system.
Note
In the output below, row A is located at the front of the chassis. The DS60 has
color coded markings on the front and rear lips of the disk bay to identify each
disk pack.
Run the following command:
disk show state
# disk show state
Enclosure Disk
Row(disk-id) 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
-------------- ----------------------------------------------
1 . . . .
2 |--------|--------|--------|--------|
| Pack 1 | Pack 2 | Pack 3 | Pack 4 |
E(49-60) |. . s |- - - |- - - |- - - |
D(37-48) |. . . |- - - |- - - |- - - |
C(25-36) |. . . |- - - |- - - |- - - |
B(13-24) |. . . |- - - |- - - |- - - |
A( 1-12) |. . . |- - - |- - - |- - - |
|--------|--------|--------|--------|
-------------- ----------------------------------------------
Legend State Count
------ ------------------- -----
. In Use Disks 18
s Spare Disks 1
U Unknown Disks 0
- Not Installed Disks 45
------ ------------------- -----
Total 19 disks
In this example, the new disks will be installed in enclosure 2, pack 2.
Adding Disks
178 EMC Data Domain DS60 Expansion Shelf Installation and FRU Replacement Hardware Guide

EMC Data Domain DS60 Specifications

General

Brand	EMC
Model	Data Domain DS60
Category	Server
Language	English