The portable lift commonly used by EMC service personnel is manufactured by Alum-
A-Lift. Instructions for this lift are included in the lift kit. Refer to "http://
www.corkc4.isus.emc.com/wiki/index.php/Lift_Tool". which describes the Lift
equipment, the ordering process, and Links to training material. The Lift Tool Training
Video and Demo on Lift tool using the Voyager assembly (Voyager is the name given
to a Disk enclosure used on many of EMC's product range), are also linked on this
page.
If you are using a portable lift other than the Alum-A-Lift, adapt these instructions as
necessary while following all required safety requirements.
The portable lift commonly used by EMC service personnel has two
configurations - one with the lower mast only and one with both the lower and
upper masts. The lower mast configuration is rated for 400 pounds and is for
raising or lowering objects 28U (49 inches) or less above the floor. The dual mast
configuration is rated well under 200 pounds and is for raising objects more than
28U (49 inches) above the floor.
l
For installations at or below 49 inches, you must use the lower mast
configuration.
l
For installations above 49 inches, use the "Voyager" conversion kit, rated for
225 pounds, and a support table with the lower mast configuration.
Reconfiguring the lift with Voyager kit
If you are using the Alum-A-Lift for installations or removals above 49 inches (28U),
you must use the single (lower) mast configuration with the "Voyager" conversion kit
and support table.
The "Voyager conversion kit," is used with multiple systems.
Procedure
1. Unpack the Voyager kit.
2. Use the instructions to provided within the kit to reconfigure the lift.
Removing and Replacing FRUs
114 EMC Data Domain DS60 Expansion Shelf Installation and FRU Replacement Hardware Guide
To Next Page
Loading...
Need help?
General
