To Next Page

To Previous Page

SC-F9200 Series Revision C

ADJUSTMENT Boards Related Checks and Adjustments 343

SE Group Confidential (Related Staff Only)

4.14.2 RTC&USB ID Input

EXECUTION MODE

Serviceman Mode

PROCEDURE

1. Turn the printer ON in the Serviceman Mode.

Turn the power ON while pressing [Menu] + [Back] + [OK].

2. Start the Service Program and select RTC&USB ID Input.

3. Check the Date and Time displayed, and correct them if necessary.

4. Click [Write RTC] to set the RTC.

5. Enter the 10-digit serial number of the printer to generate a USB ID.

6. Click [Write USB ID] to write the USB ID.

7. Click [Finish].

8. Turn the printer OFF.

9. Turn the printer on in the normal mode.

10. On the control panel, verify that the setting has been correctly applied.

If the setting is incorrect, set the date and time on the control panel.

11. Turn the printer off.

Figure 4-66. [RTC&USB ID Input] Screen

C A U T I O N

If the printer is turned OFF and back ON after changing the USB

ID, the computer (Windows) detects the USB port as a new port

and automatically copies the printer driver as xxxx (copy x). If you

need to perform another adjustment using this tool, select the

“copy x” driver.

Epson SC-F9200 series Service Manual

Other manuals for Epson SC-F9200 series