NVR User Manual 061220NA 133
window. If the testing is failed, the error message box will pop up as well.
Figure 195, Testing Result of Network Delay and Packet Loss
11.4.2
Exporting Network Packet
Purpose
By connecting the NVR to a network, the captured network data packet can be exported to a USB flash
disk, SATA/eSATA, DVD-R/W, or other local backup device.
1. Enter the Network Traffic interface, Menu > Maintenance > Net Detect.
2. Click the Network Detection tab to enter the Network Detection interface.
3. Select the backup device from the Device Names drop-down list.
NOTE: Click the Refresh button if the connected local backup device cannot be displayed.
When it fails to detect the backup device, check whether it is compatible with the NVR.
You can format the backup device if the format is incorrect.
Figure 196, Export Network Packet
4. Click Export button to start exporting.
5. After exporting is complete, click OK to finish the packet export.
Figure 197, Packet Export Attention
NOTE: Up to 1 MB of data can be exported each time.
11.4.3
Checking the Network Status
Purpose
You can also check the network status and quick set the network parameters in this interface.
To Next Page
Loading...
Need help?
General
