NVR User Manual 061220NA 26
Figure 19, Reset Password
2. Select the GUID file from the USB flash disk, and click Import to import the file to the device.
NOTE: If you import the wrong GUID file seven times, you will be not allowed to reset the
password for 30 minutes.
3. Once the GUID file is successfully imported, enter the reset password interface to set the new admin
password. See
Activating Your Device
for details.
4. Click OK to set the new password. You can export the new GUID file to the USB flash disk for future
password resetting.
NOTE: When the new password is set, the original GUID file will be invalid. The new GUID file
should be exported for future password resetting. You can also enter the User > User
Management interface to edit the admin user and export the GUID file.
2.2 Using Wizard for Basic Configuration
By default, the Setup Wizard starts once the NVR has loaded, as shown below.
Figure 20, Start Wizard Interface
Operating the Setup Wizard
1. The Setup Wizard can walk you through some important NVR settings. If you don’t want to use the
To Next Page
Loading...
Need help?
General
