HIKVISION EKI-K82T46 User Manual

NVR User Manual 061220NA 14
Chapter 1 Introduction
IMPORTANT! Not all NVRs support all features in this manual.
Some features (noted in blue type) require camera support.
Please check your hardware specifications for usage.
1.1 Front Panel (Typical)
Figure 1, Typical Front Panel
Table 1-4 Panel Description
No.
Name
Connections
1
POWER
Turns
white when device is powered up
2
HDD
Flickers white when data is be
ing read from or
written to HDD
3
Tx/Rx
Flickers white when network con
nection is functioning properly
4
Infrared
Receiver
Receiver for IR Remote control
5 USB Interface
Universal Serial Bus (USB) port for additional devices s
uch as USB mous
e and USB
Hard Disk Drive (HDD)
1.2 IR Remote Control Operations
The NVR may also be controlled with the included IR Remote control.
NOTE: Batteries (2 × AAA) must be installed before operation.
The IR Remote is set at the factory to control the NVR (using default Device ID# 255) without any additional
steps. Device ID# 255 is the default universal device identification number shared by the NVRs. You may
also pair an IR Remote to a specific NVR by changing the Device ID#, as follows:
1.2.1 Pairing (Enabling) the IR Remote to a Specific NVR (optional)
You can pair an IR Remote to a NVR by creating a user-defined Device ID#. This feature is useful when
using multiple IR Remotes and NVRs.
O
n the NVR:
1. Go to General > More Settings.

HIKVISION EKI-K82T46 Specifications

General

Brand	HIKVISION
Model	EKI-K82T46
Category	Network Hardware
Language	English