MAINTENANCE AND ADJUSTMENT OF THE UTV
- 98-
CHANGING THE COOLANT
1. Remove:
·driver seat
·passenger seat
·console
Lift the hood up.。
·coolant reservoir cap ①
·Disconnect coolant reservoir hose ②
· Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is
used instead of coolant, check and i
necessary, correct the antifreeze concentration
of the coolant；
·Use only distilled water. However, soft wate
may be used if distilled water is not available.
2. Drain:
·coolant
(from the coolant reservoir)
3. Connect:
·coolant reservoir hose
4. Remove:
·coolant drain bolt (water pump) (along with the ①
copper washer)
5. Remove:
·radiator cap ①
WARNING
:
hot radiator is under pressure. Therefore, do
not remove the radiator cap when the engine is
hot. Scalding hot fluid and steam may b
blown out, which could cause serious injury.
When the engine has cooled, open the radiato
cap as follows:
Place a thick rag or a towel over the radiato
cap and slowly turn the radiator cap
counterclockwise toward the detent to allow
any residual pressure to escape.
When the hissing sound has stopped, turn th
radiator cap counterclockwise while pressin
To Next Page
Loading...
Need help?
General
