MAINTENANCE AND ADJUSTMENT OF THE UTV
- 124-
NOTE:
Constant amperage chargers are not suitable
for charging MF batteries.
3. Install:
• battery
• Connect:
battery leads
NOTE:
First, connect the positive battery lead ①, and
then the negative battery lead ②.
• Check:
Battery terminals Dirt
Clean with a wire
brush.
Loose connection
Connect properly.
• Lubricate:
battery terminals
• Install:
battery case cover
• Close the hood.
CHECKING THE FUSES
NOTE:
Always turn off the main switch when
checking or replacing a fuse. Otherwise, a
short circuit may occur.
1. Remove:
• lift the hood up.
• battery case cover
2. Check:
• fuses
a. Connect the pocket tester to the fuse and check
it for continuity.
。
NOTE:
Set the tester to the “Ω × 1” position.
b. If the tester indicates“∞”, replace the fuse.
3. Replace:
• blown fuse
a. Turn off the ignition.
b. Install a new fuse of the proper amperage.
c. Turn on switches to verify operation of the
To Next Page
Loading...
Need help?
General
