MAINTENANCE AND ADJUSTMENT OF THE UTV
- 103-
Install the bolts ① into the secondary fixed
sheave hold.
NOTE:
Tightening the bolts ①will push the secondary
sliding sheave away, causing the gap between
the secondary fixed and sliding sheaves to
widen.
·Remove the V-belt ①from the primary sheave
and secondary sheave.
·Install the V-belt.
NOTE:
Install the V-belt so that its arrow faces the
direction shown in the illustration.
· Remove the bolts.
2. Install:
· drive belt cover
· console
· passenger seat
· driver seat
CLEANING THE SPARK ARRESTER
1. Clean:
Tap the tailpipe lightly with a soft-face hammer o
suitable tool, then use a wire brush to remove any
carbon deposits from the spark arrester portion o
the tailpipe and the inner contact surfaces of the
muffler..
2. spark arrester
WARNING:
·
Select a well-ventilated area free o
combustible materials.
·
Always let the exhaust system cool befor
performing this operation.
·
Do not start the engine when removing the
tailpipe from the muffler.
3. Remove:
To Next Page
Loading...
Need help?
General
