MOVING THE MACHINE
4-1
Driving the Machine
Correct operation will result in extending the service life of
each part and component as well as saving fuel and oil.
Always be sure to safely and efficiently operate the
machine while paying attention to the following points.
IMPORTANT: The engine must be started and ready
for driving correctly by referring to the previous
section “OPERATING THE ENGINE”.
Precautions for Starting to Move
1. Perform a thorough walk-around inspection.
Conduct correct start-up procedure.
2. After raising the lift arm, set the lift arms and bucket
in the operating position.
3. Before driving on public roads, set the machine to the
driving position as illustrated to the right.
4. Be sure to press lock ( ) side of control lever lock
switch (1) so that the linkage will not move even if
the control levers are accidentally moved.
Position
A: 545 mm (21.5 in)
115Z7B-4-1-1
A
1
Multi-Function Joystick Type
MNEC-01-043
Fingertip Control Type
1
115Z7B-1-9-4
To Next Page
Loading...
Need help?
General
