Honeywell CNI2 User Manual

CNI2
O
perating and Installation
Guide
106
CODE
DESCRIPTION
41
TCP/IP variables could not be initialized. This is generally a firmware
problem.
42
Could not establish a point
-
to
-
point (PPP) connec
tion with network. This
might be caused by the cellular account not being setup for Internet service.
It could also be caused by an incorrect PAP username or password, or an
incorrect APN for GSM service.
43
Could not establish a TCP/IP connection to th
e destination server. This
might be caused by the cellular account not being setup for Internet service.
It could also be caused by an incorrect PAP username or password.
44
Error sending data to the destination server. This is usually caused by an
une
xpected termination of a connection due to network problems or poor
signal conditions.
45
Error receiving data from the destination server. This is usually caused by
an unexpected termination of a connection due to network problems or poor
signal conditio
ns.
46
Unexpected command from
the data collection system
. This might indicate
a problem with the way the
CNI2
is setup in
the data collection system
.
47
Not used
48
Not used
49
Not used
51
Unexpected response from
the data collection system
. This mi
ght indicate a
problem with the way the
CNI2
is setup in
the data collection system
.
52
The memory address specified in a memory write command from the host
system (
the data collection system
) is illegal. This might indicate a problem
with the way the
CN
I2
is setup in
the data collection system
.
53
Unexpected message received from
the data collection system
to terminate
the connection. This can be caused by network problems or poor signal
conditions.
54
Message from
the data collection system
was too l
arge. This might indicate
a problem with the way the
CNI2
is setup in
the data collection system
.
55
Over
-
the
-
air configuration update command contained a memory address
outside of the configuration memory area.
56
Unrecognized command from
the data col
lection system
or an inappropriate
combination of commands was received. This might indicate a problem with
the way the
CNI2
is setup in
the data collection system
.
57
Not used.
58
Message from
the data collection system
had an incorrect CRC value. This
is usually caused by an unexpected termination of a connection due to
network problems or poor signal conditions.
59
Not used
LED Error Codes 41 thru 59

Honeywell CNI2 Specifications

General

Brand	Honeywell
Model	CNI2
Category	Recording Equipment
Language	English