Honeywell CNI2 User Manual

CNI2
O
perating and Installation
Guide
40
JP6
JUMPER OUT
JUMPER IN
1
-
2
Not used (storage for spare jumper)
Not used (storage for spare jumper)
3
-
4
Not used (storage for spare jumper)
Not used (storage for spare jumper)
5
-
6
*** Enables normal operation
Enables
factory
tes
t mode
7
-
8
Not used (storage for spare jumper)
Not used (storage for spare jumper)
9
-
10
*** Directs programming cable to Main
Processor
Directs programming cable to Aux
illiary
Processor
11
-
12
Disconnects on
-
board pull
-
ups for digital
lines 1, 2, 3, 4, 5
and 8.
*** Connects on
-
board pull
-
ups for digital
lines 1, 2, 3, 4, 5 and 8.
13
-
14
Disconnects on
-
board pull
-
ups for analog
input lines 1 thru 6.
*** Connects on
-
board pull
-
ups for
analog input lines 1 thru 6.
15
-
16
Disconnects on
-
board pull
-
ups for dig
ital
lines 6 and 7.
*** Connects on
-
board pull
-
ups for digital
lines 6 and 7.
*** = Recommended setting
Jumper Block JP6 Settings
JP3
A
-
B
B
-
C
1
Not used (storage for spare jumper)
Not used (storage for spare jumper)
2
CNI2
wakes up on change in D
TR serial
input line
***
CNI2
wakes up on change in RXD
serial input line
3
+3.3V / 0V non
-
inverted RXD input on serial
port.
*** ±5.5V inverted (RS
-
232) RXD input on
serial port.
4
*** Allows
CNI2
to shut
-
down the on
-
board 3.6V regulator when not needed
.
Permanently enables the on
-
board 3.6V
regulator. Normally only used for factory
testing or special applications.
5
*** Allows
CNI2
to shut
-
down the on
-
board 3.6V regulator when not needed.
Permanently enables the on
-
board 3.6V
regulator. Normally on
ly used for factory
testing or special applications.
*** = Recommended setting
Jumper Block JP3 Settings
Connector J4
This connector provides direct access when performing a firmware download or configuration
change when using the MP32 software and pro
gramming cable.

Honeywell CNI2 Specifications

General

Brand	Honeywell
Model	CNI2
Category	Recording Equipment
Language	English