perating and Installation
Assembly sequence for the backside hangers is shown in the illustration below. The lock
washer contacts directly with the enclosure, then the hanger, the f
lat washer, and lastly the
screw to secure. Tighten the screw until snug, but do not over
Wall Mount Hangers Assembly Sequence
Where it is desired to have an index base mounted directly to a meter, the UMB
package are that the entire
instrument can be mounted without any concerns about routing external meter pulse signal
wires. Mounting of the UMB index base is possible on rotary, turbine, and diaphr
meters that have a rotating instrument drive output. This includes American, Rockwell, Romet,
Roots, or Schlumberger meters.
The UMB housing may be rotated about the base plate so that the instrument and index will
all four screws which attach the base plate to the
Replace and tighten the four screws after you have repositioned the UMB
To Next Page
Loading...
Need help?
General
