Honeywell CNI2 User Manual

CNI2
O
perating and Installation
Guide
107
CODE
DESCRIPTION
61
Not used
62
Not used
63
Not used
64
Not used
65
Not used
66
Not used
67
Not used
68
Not used
69
Not used
71
Configuration memory has not been programmed or is corrupt. Attempt to
reload the configuration. This could be caused by a nearly
-
depleted battery.
Otherwise the FLASH memory in the processor is defective.
72
There is a data retention or communications problem with the non
-
volatile
EEPROM memory device.
73
Could not write into FLASH memory. This is a problem with the processor.
74
Over
-
the
-
air firmware download was aborted. This is usually a network
-
relat
ed problem or
problems with the
the data collection system
data
collection system.
75
The watchdog timer expired and generated a reset. This could be caused
by defective firmware but might also be caused by a defective crystal.
76
Not used
77
Not used
78
Not used
79
Not used
LED Error Codes 61 thru 79
LEDS AFTER OVER
-
THE
-
AIR
RE
PROGRAMMING
If a new operating program (“firmware”) is successfully downloaded over
-
the
-
air the call will
complete as normal. Then the LEDs will rapidly flash in an alter
nating pattern for anywhere
between 10
–
30 seconds as the
CNI2
reprograms itself. At the end of the operation the
CNI2
will return to “sleep” mode
and both LEDs will turn off
.

Honeywell CNI2 Specifications

General

Brand	Honeywell
Model	CNI2
Category	Recording Equipment
Language	English