Operation - Stream Configuration
Part No.: 4418309_Rev09 Fusion4 MSC-L
Honeywell Installation & Operation Manual 5 - 159
Table of valid ranges for this commodity group as stipulated in MPMS
11.2.4:
CAUTION! Compensation for pressure effects should be used
above 10 bar product pressure.
When density sensor input is used, not all sets of observation values
may result in a proper calculation values bound by stipulated ranges.
This is the expected behavior for these calculations (an exception is
raised if a proper value cannot be calculated).
5.14.1.4.2.4 EN14214 (2008), Commodity Group FAME (Fatty Acid Methyl Esters)
There is currently no compensation for pressure effects for this
commodity group.
Table of valid ranges for this commodity group:
5.14.1.4.2.5 CNP6-70, Commodity Group Petroleum (Brazilian Standard)
The calculation of the pressure conversion factor is not included directly
into the CNP6-70 Tables, therefore MPMS 11.2.1M (utilizing D1250-04
procedures) is used in addition for calculating the compressibility of the
fluid. Iterative process is used in this case to establish density at
reference conditions, which in turn is used to derive CTPL (VCF).
Table of valid ranges for this commodity group:
NOTE: Temperature range depends on density as
determined by CNP6-70 Tables I and II.
5.14.1.4.2.6 NBR15639 (2008), Commodity Group Alcohol (Ethanol Mixture with Water)
There is currently no compensation for pressure effects for this
commodity group.
Fluid Property Minimum value Maximum value
Temperature, °F -50.8 +199.4
Temperature, °C -46 +93
60.0°F relative density 0.3500 0.6880
Density at 15.0°C, kg/m
3
351.7 687.8
Density at 20.0°C, kg/m
3
331.7 683.6
Fluid Property Minimum value Maximum value
Temperature, °C +20.0 +60.0
Density at 15.0°C, kg/m
3
860 900
Fluid Property Minimum value Maximum value
Temperature, °C -50.0 (-60.0 Ext.) +200.0 (+240.0 Ext.)
Density at 20.0°C, kg/L 0.500 (0.450 Ext.) 1.100 (1.250 Ext.)
To Next Page
Loading...
Need help?
General
