Honeywell Fusion4 MSC-L User Manual

System Description - Introduction
Fusion4 MSC-L Part No.: 4418309_Rev09
3- 2 Installation & Operation Manual
Honeywell
3.1.2.1 Batch Flow Stages
Following are the four batch flow stages for the MSC-L.
 Initial Flow Phase
 Full Flow Phase
 Pre-Stop Phase
 Clean Arm Volume
The following image illustrates how the actual batch blend percentage
may vary during the load based on the various configuration settings.
For instance, if the initial flow rate is too small for accurate blend
product measurement, then blending only starts in the Full Flow Phase.
Secondly, if the clean arm functionality is configured, then the MSC-L
intentionally over blends to ensure that all the required blend products
are dispensed before the clean arm phase begins.
NOTE: To adequately match various specific applications,
the MSC-L has a number of configurable
parameters. For an explanation of all these
parameters and their specific settings, see chapter 5
"Operation".

Honeywell Fusion4 MSC-L Specifications

General

Brand	Honeywell
Model	Fusion4 MSC-L
Category	Desktop
Language	English