Reference Code Description/Action Perform all actions before exchanging Failing Items Failing Item
9800 to 9803 I/O processor successfully recovered from temporary error
No action required. This reference code is logged for information only.
9810 Problem analysis has determined a part should be replaced.
This reference code is used for ending Online Problem Analysis with a list
of failing items. (Information Only)
9899 Problem analysis completed, the problem has been corrected.
This reference code is used for ending Online Problem Analysis when no
problem was found or the problem was corrected.
UHQFIXD
9900 Licensed Internal Code for tape unit was not upgraded
The I/O processor loading of Licensed Internal Code (LIC) to the
programmable tape unit was not completed.
The tape unit will continue to operate with the previous LIC. You may do
either of the following:
v Wait for next IPL when the system will attempt to load the LIC for the
tape unit again.
v Perform “TU-PIP4” on page 453 to reset the IOP and the tape unit. When
the IOP is reset, if the device has the wrong level of LIC, the IOP will
attempt to load the new LIC.
FFF6 Tape volume statistics logged (no action required)
Tape Unit Failing Items
Notes:
1. To determine the failing items, go to “Failing Items” on page 479.
2. To determine the associated part numbers, go to “Type, Model, and Part
Number list” on page 885.
3. To determine the parts associated with symbolic FRUs, such as “ANYBUS”,or
“DEVTERM”,goto“Symbolic FRUs” on page 495.
Failing Item Description Document Description
05H3834 Interposer IBM 3590 Tape Drive Service Guide
61G8324 Terminating plug IBM 3590 Tape Drive Service Guide
ANYFC Any Fibre Channel device Problem Analysis; Symbolic FRU Isolation
EXTSCSI External signal cable Problem Analysis; Symbolic FRU Isolation
FCCABLE Fibre Channel cable Problem Analysis; Symbolic FRU Isolation
FCCODE Gateway device Licensed Internal Code Problem Analysis; Symbolic FRU Isolation
FCDEV Fibre Channel device Problem Analysis; Symbolic FRU Isolation
FCGATE Gateway device IBM SAN Data Gateway Service Guide
FCIOA Fibre Channel IOA Problem Analysis; Symbolic FRU Isolation
MHQTMED Defective removable media Magnetic tape subsystem service information
UHQCLN Tape unit needs cleaning Magnetic tape subsystem operator’s information
UHQCNFG Tape configuration detected by I/O processor;
not valid
Installation
3590
150
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
To Next Page
Loading...
Need help?
General