IBM i 830 User Manual

11. Disconnect and label any cables from the card that you wish to remove.
12. Turn the blue latch counter clockwise and lift upward on the black latch to
release the card.
Note: If you are removing a FC 2890, then you must use dedicated
maintenance.
13. Remove the card by gently pulling it out.
14. Install the card in to the system by reversing the card removal procedure for
the model system or tower that you are working on.
15. Select the Power on domain option for the IOA or IOP that you are installing.
Note: To the right of the description field you will see one or both of the
following symbols displayed:
*
>
The * indicates the location to which the system will assign the
resource. Where as the > indicates the location to which the resource
was last assigned.
16. Press enter, the “Work with Controlling Resources” screen will appear.
17. Determine the location where you want to assign the resource and select the
assign to option for that location.
18. Wait for the ″Hardware Resource Concurrent Maintenance″ display to appear
with the message indicating power on complete.
19. After exchanging the failing item, then go to “Verifying the Repair” on
page 920.
Note: If you have exchanged a 2766 Fibre Channel IOA, the IBM 2105 disk
unit subsystem must be updated to use the World-Wide Port-Name of
the new 2766 IOA. This name can be found in the Port worldwide
name field on the iSeries 400 by displaying detail on the 2766 IOA
Logical Hardware Resource information in Hardware Service Manager
in SST/DST. The 16-digit World-Wide Port-Name can also be
determined by including the digits ″1000″ to the beginning of the
12-digit IEEE Address found on the tailstock label of the Fibre Channel
IOA. Use the ESS Web Interface User’s Guide (SC26–7346) to update the
World-Wide Port-Name in the host configuration on the IBM 2105 ESS.
The ESS Web Interface User’s Guide can also be found at the following
URL: http://www.storage.ibm.com/hardsoft/products/ess/refinfo
This ends the procedure.
FC 5078/0578 – Cards – Dedicated
Attention: All cards are sensitive to electrostatic discharge (see “Appendix C.
Working with Electrostatic Discharge-Sensitive Parts” on page 955).
CAUTION:
The circuit card contains lead solder. To avoid the release of lead (Pb) into the
environment, do not burn. Discard the circuit card as instructed by local
regulations. (RSFTC234)
Remove and Replace Procedures
Chapter 4. Removal and Installation Procedures 649

IBM i 830 Specifications

General

Brand	IBM
Model	i 830
Category	Server
Language	English