21. Exchange the card multi-adapter bridge’s FRU at the card position that you
determined for it. To determine the removal and installation procedure for the
multi-adapter bridge’s FRU, locate the FRU’s card position in the ″FRU
Locations and Failing Items″ table for the frame type that you recorded. ″FRU
Locations and Failing Items″ tables are in “Locations and Addresses” on
page 705.
22. Install all IOPs and IOAs in their original positions.
23. Power on the system or partition.
Does the SRC or failure that sent you to this procedure occur?
No Yes
↓ Call your next level of support.
This ends the procedure.
24. Perform “BUS PIP VERIFY - RA” on page 323.
This ends the procedure.
BUS PIP PCIBUS-PIP1
PCIBUS-PIP1: PCI Adapter Card Position Procedure.
If you were sent to this procedure with a specific Direct Select Address (DSA) then
use that DSA in this procedure. Otherwise use the DSA in word 7 of the B6xx SRC,
see “Breaking Down The SRC” on page 280 for help in locating the DSA.
1. Record the bus number value, BBBB, in the DSA. See the Table 7 on page 281
for help in locating the BBBB value in the DSA. You must convert the BBBB
value to decimal. Search for the decimal bus number in HSM or the System
Configuration Listing to determine which frame or I/O tower contains the
failing item. Record the frame or tower type.
2. Record the Cc value in the DSA. See Table 7 on page 281 for help in locating
the Cc value in the DSA.
3. Is the Cc value greater than 00 ?
Yes No
↓ The multi-adapter bridge and the multi-adapter function number are
not identified. Record that the multi-adapter bridge is not identified in
the DSA. The card slot cannot be identified using the DSA. Go to step
8 of this procedure.
4. Is the right-most character of the Cc value ’F’?
No Yes
↓ Only the multi-adapter bridge number is identified. Record the
multi-adapter bridge number (the leftmost character of the Cc value)
for later use. The card slot cannot be identified using the DSA. Go to
step 8 of this procedure.
5. Is SST/DST available?
No Yes
↓ Go to step 14 of this procedure.
6. Use the “Card Position Tables” on page 282 with the BBBB and Cc values that
you recorded to identify the card position. Use the Card Position Table that
matches the frame or I/O tower type that you recorded.
7. Return to the procedure, FI or symbolic FRU that sent you here.
8. Perform the following:
Bus, High-Speed Link (HSL) PIPs
320
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
To Next Page
Need help?
General