UG3AS
An error has been detected in iSeries 400 Licensed Internal Code.
Contact your next level of support for possible corrective actions.
This ends the procedure.
UJ0E7
Local System Remote System
or Controller
┌──────────┐ ┌──────────┐
││ ││
││ ││
│ │ Local Modem Remote Modem │ │
│ │ ┌───────────┐ ┌───────────┐ │ │
│ ├────┤ ├──────//──────┤ ├────┤ │
│ │ └───────────┘ └───────────┘ │ │
││ ││ ││
││ ││ ││
││ ││ ││
││ ││ ││
└──────────┘ The problem is here. └──────────┘
The problem has been isolated to the telephone line equipment that links the local
and the remote equipment.
This ends the procedure.
UJ6P3
An error occurred in the IBM Facsimile Support/400 Licensed Program.
Please contact your next level of support for possible corrective actions.
Find additional information on Facsimile Support for OS/400 in the Application
System Facsimile Support for OS/400 User’s Guide.
This ends the procedure.
UJA34
The line configuration parameter that was identified as a possible problem can be
changed by using the WRKLIND command. Determine if the suspected
configuration parameter is wrong and change if necessary. Information about
commands related to communications can be found in the following manuals:
v CL Programming, SC41-5721-03
v Communications Configuration, SC41-5401-00
Some software problems can be temporarily solved by changing the configuration
parameter, even if the original value was correct. Report this problem to your
service representative if you use this temporary change.
This ends the procedure.
Symbolic FRUs
604
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
To Next Page
Loading...
Need help?
General