Problem or Message Meaning or Corrective Action
PCI I/O processor rejected assignment or
removal of an IOA
The I/O processor’s (IOP) licensed internal
code (LIC) has rejected the assignment of an
I/O adapter (IOA) to that IOP, or the IOP’s
LIC has rejected the removal of an IOA
which the IOP owns.
Word 5 of the SRC is the Direct Select
Address (DSA) of the IOP. Word 7 of the
SRC is the DSA of the IOA.
a. Use the “Card Position Tables” on
page 282 with the DSA in word 5 of the
SRC to locate the IOP.
b. Use the “Card Position Tables” on
page 282 with the DSA in word 7 of the
SRC to locate the IOA.
Use HSM concurrent maintenance functions
to assign or remove the IOA. See the iSeries
Service Functions manual for help in using
the HSM concurrent maintenance functions.
Assignment failures can be from:
v The IOP already being at its capacity to
accept IOA assignments.
v The IOA is not a type supported by the
IOP.
Corrective action:
v Add another IOP for LIC to assign the
IOA to if necessary.
v Reassign the IOA to another IOP using
concurrent maintenance.
Removal failures:
v This is a LIC problem and should be
reported.
v Call you next level of support.
This ends the procedure.
MA_BRDG
MA_BRDG: multi-adapter bridge.
This is the multi-adapter bridge hardware on a system bus.
1. Is the location information for this failing component available in the Service
Action Log?
No Yes
↓ Use the location information in the Service Action Log and go on to
step 4 on page 555 of this procedure.
2. Were you sent here by an A6xx xxxx or B6xx xxxx SRC and no location
information was available in the Service Action Log?
No Yes
Symbolic FRUs
554
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
To Next Page
Loading...
Need help?
General