IBM i 830 User Manual

Reference
Code
Description/Action Perform all actions before exchanging
Failing Items
Failing Item Location
4691 to 4697 Service processor Licensed Internal Code
Perform INT-PIP24.
AJDGP01
4698 Operator/User Error OPUSR
4699 Service processor Licensed Internal Code
Perform INT-PIP24.
AJDGP01
469A Service processor Licensed Internal Code
Perform INT-PIP24.
AJDGP01
AJDG301
469B Service processor LIC problem
Record all the SRC data words, attempt a main storage dump,
and replace the FRUs listed if necessary.
AJDG301
BUS1
469C Service processor Licensed Internal Code
Perform INT-PIP24, then replace the FRUs listed if necessary.
AJDGP01
BUS1
469D Service processor Licensed Internal Code
If this SRC is displayed at the system console dump manager
screen then save the main storage dump and report the LIC
failure to service. If this SRC is displayed at the control panel
then perform INT-PIP24.
AJDGP01
469E Service processor Licensed Internal Code
Perform INT-PIP24.
AJDGP01
SYSUNIT
SVCPROC
469F Service processor Licensed Internal Code
Perform INT-PIP24.
AJDGP01
SVCPROC
SYSUNIT
4998 Operator/User Error UCSUSER
6010 Any device attached to Bus 1 BUS1
8FF0 Information only, no service action required
Service processor error log entry.
If the secondary refcode is 806A, a successful
download of control panel code has occured.
If the secondary refcode is 8EEE, one of the following
conditions may have occured.
Operation was successful but current
keylock position was not in Auto or normal.
The Time-of-Day (TOD) chip had to be reset
due to an invalid power-up state. TOD
requests will not work successfully until
a write TOD is done (CHGSYSVAL QDATE).
Timed-Power-On request has been acknowledged.
Power on sequences must be set for valid months,
days, hours, minutes, and seconds, for future
times, and for times when the system will be
powered off.
A1xx, B1xx
Chapter 2. Unit Reference Codes 181

IBM i 830 Specifications

General

Brand	IBM
Model	i 830
Category	Server
Language	English