Keithley 2701 User Manual

10-12 Remote Operations Model 2701 User’s Manual
Ethernet settings
NOTE Ethernet fundamentals and details on the valid Ethernet settings are provided in
the Model 2701 Instrument Networking Manual. The following information
explains how to use the front panel Ethernet menu and SCPI commands to check
and/or change Ethernet settings.
Ethernet settings include the following:
• Dynamic Host Control Protocol (DHCP) – Enable or disable.
• IP address
• Subnet mask
• Ethernet gateway
• MAC address of the 2701 – This fixed address for the 2701 cannot be changed.
Ethernet settings can be made from either the front panel or remote programming.
NOTE Error code +550 Unitialized Ethernet module will occur on power-up if the
Ethernet settings are corrupt or the MAC address is FF:FF:FF:FF:FF:FF.
Contact Keithley immediately if this error occurs. Make sure to have the serial
number of you Model 2701 handy when you call. The serial number is displayed
from the SETUP menu. Press SHIFT and then SETUP to access the menu, then
use the up RANGE key to display the serial number (SNUM).
When you call, Keithley will give you the MAC address of your unit. After you
have the address, press SHIFT and then ETHERNET to bring up the MAC
address edit mode. You can then enter the new address in decimal.
Contact information for Keithley and its worldwide offices are located on the
WARRANTY page located at the front of this manual. Contact the sales office
nearest to you.

Keithley 2701 Specifications

General

Brand	Keithley
Model	2701
Category	Multimeter
Language	English