Sweep Operation 9-7
commands. The SCPI command reference tables, Tables 17-1 through 17-11, also list source
memory parameters.
Table 9-2
Source memory saved configurations
Mode Remote command
Current integration rate
Resistance integration rate
Voltage integration rate
Concurrent functions
Enable functions
Disable functions
Manual/auto ohms
Offset-compensated ohms
Enable/disable filter
Filter type
Filter count
Source mode
Source delay
Source auto delay
Scaling factor*
Enable/disable scaling*
Source Value, Range, Auto Range
Sense Protection, Range, Auto Range
Enable/disable auto-zero
Enable/disable remote sense
Front/rear terminals
Enable/disable CALC1
CALC1 math expression
CALC2 input path
REL value
REL on/off
Limit 1 on/off
Limit 1 fail conditions
Limit 1 bit pattern
Enable/disable Limit X**
Limit X upper limit
Limit X upper bit pattern
Limit X lower limit
Limit X lower bit pattern
Composite limits bit pattern
Next pass memory location
Trigger delay
SENSe[1]:CURRent:NPLCycles
SENSe[1]:RESistance:NPLCycles
SENSe[1]:VOLTage:NPLCycles
SENSe[1]:FUNCtion:CONCurrent
SENSe[1]:FUNCtion:ON
SENSe[1]:FUNCtion:OFF
SENSe[1]:RESistance:MODE
SENSe[1]:RESistance:OCOMpensated
SENSe[1]:AVERage:STATe
SENSe[1]:AVERage:TCONtrol
SENSe[1]:AVERage:COUNt
SOURce[1]:FUNCtion:MODE
SOURce[1]:DELay
SOURce[1]:DELay:AUTO
SOURce[1]...X...:TRIGgered:SFACtor
SOURce[1]...X...:TRIGgered:SFACtor:STATe
SYSTem:AZERo:STATe
SYSTem:RSENse
ROUTe:TERMinals
CALCulate1:STATe
CALCulate1:MATH[:EXPRession]:NAME
CALCulate2:FEED
CALCulate2:NULL:OFFSet
CALCulate2:NULL:STATe
CALCulate2:LIMit[1]:STATe
CALCulate2:LIMit[1]:COMPliance:FAIL
CALCulate2:LIMit[1]:COMPliance:SOURce2
CALCulate2:LIMitX:STATe
CALCulate2:LIMitX:UPPer[:DATA]
CALCulate2:LIMitX:UPPer:SOURce2
CALCulate2:LIMitX:LOWer[:DATA]
CALCulate2:LIMitX:LOWer:SOURce2
CALCulate2:CLIMits:PASS:SOURce2
CALCulate2:CLIMits:PASS:SMLocation
TRIGger:DELay
**X = CURRent or VOLTage.
**Limit X = Limit 2, 3, 5-12.
To Next Page
Loading...
Need help?
General
