SCPI Command Reference 17-97
RS-232 interface
:LOCal
:SYSTem:LOCal Take SourceMeter out of remote
Description Normally, during RS-232 communications, front panel keys are operational.
However, the user may wish to lock out front panel keys during RS-232
communications. See :RWLock.
This action command is used to remove the SourceMeter from the remote
state and enables the operation of front panel keys. Note that this command
can only be sent over the RS-232 interface.
:REMote
:SYSTem:REMote Place the SourceMeter in remote
Description This action command is used to place the SourceMeter in the remote state.
In remote, the front panel keys will be locked out if local lockout is asserted.
See :RWLock. Note that this command can only be sent over the RS-232
interface.
:RWLock <b>
:SYSTem:RWLock <b> Disable or enable front panel keys
Parameters <b> = 0 or OFF Disable local lockout
1 or ON Enable local lockout
Query :RWLock Query state of local lockout
Description This command is used to enable or disable local lockout. When enabled, the
front panel keys are locked out (not operational) when the instrument is in
remote. (See :REMote.) When disabled, the front panel keys are operational
in remote.
Removing the instrument from remote (:LOCal) restores front panel keys
operation but does not change the status of the :RWLock command.
Note that this command can only be sent over the RS-232 interface.
Query timestamp
:TIME?
:SYSTem:TIME? Query timestamp
Query :TIME? Query timestamp
Description This query returns the current timestamp value.
To Next Page
Loading...
Need help?
General
