Keithley 6430 User Manual

Remote display programming 1-16
source delay 3-10
source-measure procedure 3-12
sweep operation 9-11
tests 1-16, 20-3
Trigger model 10-2
V-source protection 3-9
Fuse
Line, replacement 20-2
replacement 1-14
G
General
bus commands
13-6
information 1-2
measurement considerations F-14
purpose probes 1-4
General operation notes G-5
Generated currents F-6
GET (Group Execute Trigger) D-8
GET (group execute trigger) 13-8
Getting Started 1-1
GPIB 10-4
488.1 Protocol G-1
connections 13-4
defaults 10-22
Front panel operation 13-9
operation 13-4
reading speed comparisons G-6
standards
13-4
status indicators 13-9
Grading mode 11-4
limit testing 11-5
Ground loops F-14
GTL (Go To Local) D-8
GTL (go to local) 13-7
GUARD 12-7
Guard 5-22, 12-9
selection 2-13
sense 5-24
Guarding an ionization chamber F-4
H
HALT 10-15
Handle 1-8
Handler interface 11-10
Handshake lines D-5
heat sink 3-2
Humidity F-8
I
Idle 10-2, 10-16
IEEE command groups D-13
IEEE-488
Bus description D-2
Bus lines D-4
Bus Overview D-1
connector 13-4
IEEE-488 documentation requirements E-3
IFC (Interface Clear) D-5, D-8
IFC (interface clear) 13-7
IMMEDIATE 10-4, 10-5
IMMediate 10-18, 10-19
Initialize memory
17-90
Initiate source/measure cycle 17-102
Input capacitance (settling time) F-11
Input trigger requirements 10-8
Inspection 1-3
Interface
function codes D-14
Selecting an 13-3
INTERLOCK 12-7
Interlock
control 17-52
Safety 12-6
Test fixture 2-5
Introduction
Calibration 19-2
Data flow
C-2
GPIB 488.1 Protocol G-2
IEEE-488 and SCPI Conformance
Information E-2
IEEE-488 Bus Overview D-2
Performance Verification 18-2
Routine Maintenance 20-2
I-Source
boundaries 5-11
K
Key press
simulate 17-95
Key-press
codes 17-96
KEYS test 20-3
L
L (Listener Function) D-14
LAG (Listen Address Group) D-9
LE (Extended Listener Function) D-15
Leakage currents and guarding F-3

Keithley 6430 Specifications

General

Brand	Keithley
Model	6430
Category	Measuring Instruments
Language	English