Action Yes No
Step 3
If applicable, make sure that the option card is supported.
Does the problem remain?
Go to step 4. The problem is
solved.
Step 4
Check the controller board pins for damage, and replace if
necessary. See
“Controller board removal” on page 409.
Does the problem remain?
Go to step 5. The problem is
solved.
Step 5
Make sure that the firmware version installed is the latest, and
update if necessary.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
Excess options service check
Action Yes No
Step 1
Reset the printer, and then resend the print job.
Does the problem remain?
Go to step 2. The problem is
solved.
Step 2
If applicable, make sure that the internal option is supported.
Does the problem remain?
Go to step 3. The problem is
solved.
Step 3
a If applicable, remove all internal options.
b Reset the printer, and then resend the print job.
Does the problem remain?
Go to step 6. Go to step 4.
Step 4
Check if the number of internal options installed is allowed, and
remove the excess option.
Does the problem remain?
Go to step 5. The problem is
solved.
Step 5
Check if the number of input options installed is allowed, and
remove the excess option.
Does the problem remain?
Go to step 6. The problem is
solved.
7528
Diagnostic information
179