126 and 127 error messages
Error code Description Action
126.01 LVPS line voltage error was detected. See
“LVPS service check” on page 200.
126.02 LVPS line voltage error was detected.
126.06 LVPS 25V line error was detected.
126.07 LVPS 5V rail was down during POR.
126.10 No line frequency was detected.
126.11 Line frequency has gone outside the operating
range.
127.01 HVPS primary power supply was not detected. See
“HVPS service check” on page 200.
127.02 HVPS secondary power supply was not detected.
128 error message
Error code Description Action
128.00 TPS communications error See
“TPS communications service check” on
page 212.
142 error messages
Error code Description Action
142.80 The motor (CM developer) did not turn on. See
“Motor (CM developer) service check” on
page 201.
142.81 The motor (CM developer) did not turn o.
142.82 The motor (CM developer) speed did not ramp up
to the required level.
142.83 The motor (CM developer) stalled.
142.84 The motor (CM developer) ran too slow.
142.85 The motor (CM developer) ran too fast.
142.86 The motor (CM developer) did not run at the
correct timing.
7528
Diagnostic information
186