Revision:1.0(2023-01-12)
153
• Tool: soft brush
• Method:
1. Before cleaning, remove the dust-proof net. In the direction shown in the figure below, press
the elastic buckle of the dust-proof net cover upwards and turn it outward to remove the dust-
proof net.
2. Clean the dust-proof filter: Gently brush off the dust from dust-proof filter with a soft brush.
3. Install the dust-proof net: Install the dust-proof net by performing operations in reserve order of
the dust-proof net removal procedure, and reinstall the main unit box and display back to the
trolley.
Clean all the dust-proof filters of the machine regularly (once a month), otherwise it is
easy to cause damage to the machine. When the machine is used outdoors or in other
dusty places, increase the cleaning frequency.
55..11..22..33 Cleaning the Display (Touch Screen)
•
Tools: dry soft cloth, water or mild soapsuds
• Method: Directly use a dry soft cloth to clean the surface of touch screen. If there is still a stain,
dip a dry soft cloth with a little water or mild soapsuds to wipe and then air dry the touch
screen.
55..11..22..44 Cleaning the Probe
•
Tools: mild soapsuds, and dry soft cloth
• Method:
1. Use a dry soft cloth to wipe off the dust on the head of the probe, connector housing, and
cable.
2. Use a soft brash to generally remove the dust on the probe connector terminal.
3. If there are still stubborn stains, dip a dry soft cloth with a little mild soapsuds to wipe off dust or
stains on the surface of the probe cable or connector housing, and then air dry them.
Do not wipe the probe connector using a wet cloth.
Diagnostic Ultrasound System
Service Manual
5 Maintenance
To Next Page
Loading...
Need help?
General
