Revision:1.0(2023-01-12)
98
When the display is in the portrait mode, the display angle can be adjusted backward, as shown in
the following figure.
3.6 Connecting Peripherals
3.6.1 Connecting the Footswitch
Do not connect more than one footswitch to the main unit, as doing so may cause the
system to malfunction.
The system can use a USB-based wired footswitch.
• Connect
Plug the USB connector of the wired footswitch into a vacant USB port of the system.
• Set key functions
You can set the functions of the footswitch. For details, see 3.7.11
Setting the Footswitch.
3.6.2 Connecting the Video Printer
The system can work with a black-and-white or color digital video printer.
1. Place the printer in an appropriate position.
2. Connect the power cord of the printer to a receptacle. Use a USB cable to connect between the
USB port of the system and the USB port of the printer.
3. Fill the printer with printing paper, and turn on the ultrasonic system and printer.
Diagnostic Ultrasound System
Service Manual
3 Installation
To Next Page
Loading...
Need help?
General
