Revision:1.0(2023-01-12)
194
7.1.3 Personnel Requirements
Only technical professionals from Mindray or engineers authorized by Mindray after training can
perform assembly and disassembly.
7.1.4 Assembly/Disassembly Requirements
Make the following preparations before disassembling the ultrasound device:
1. Stop scanning and image capture, shut down the system, disconnect the AC power supply, and
remove the AC power cable.
2. To prevent scratching the surface of the device, prepare a soft workbench that is clean without
sundries.
3. Prepare the tools required.
7.1.5 Sketch
This section describes the disassembly processes of major assemblies and hardware boards.
The assembly process is the inversed disassembly process unless otherwise specified.
The illustration of assembly/disassembly is provided for reference only, and the
concrete picture depends on the actual model.
Diagnostic Ultrasound System
Service Manual
7 FRU Replacement
To Next Page
Loading...
Need help?
General
