Revision:1.0(2023-01-12)
96
1 Knockout hole
2 Slot at the battery pack bottom
3 Two screws tightened by hand
4 Spring pin
3.4.9 Connecting the probe
Connecting/Disconnecting the probe
• Freeze an image or turn off the power of the system before connecting/disconnecting
the probe. Otherwise, system or probe failure may occur.
• When connecting or disconnecting the probe, place it in a proper position, to prevent
the probe from falling off or becoming damaged.
• Only use the probes provided by Mindray. Aftermarket probes may result in damage
or cause a fire.
Connecting the Probe
Before connecting the probe, make sure the probe, probe cable, and probe connector
are free from cracks or peeling surface. Using a defective probe may result in an electric
shock to the patient.
Installation method:
1. Push the probe connector into the probe socket carefully.
2. Move the probe locking lever to the locked position to lock the probe connector.
Diagnostic Ultrasound System
Service Manual
3 Installation
To Next Page
Loading...
Need help?
General
